28
EN
pewag levo clamp LC
To adjust the power save mode, please proceed as follows:
Hold down the status query + clamp lighting button
simultaneously until the pewag levo remote battery
the status display lights up (approx. after 10 sec.). Now you are
in the configuration mode.
Activate the power save mode:
Activate the power save mode by pressing the light button.
The activation of the power save mode is shown by a flashing
light on the status display.
Deactivate the power save mode:
Deactivate the power save mode by pressing the status query
button. The deactivation of the power save mode is shown by a
permanent light showing on the status display.
The configuration mode will finish automatically after 5 seconds.
5.4 Connecting the pewag levo clamp
LC with the radio control unit
To operate the pewag levo clamp LC with the radio control
unit, both devices have to be connected. Basically, it is already
connected when it is delivered. If this is not the case, please
proceed as follows:
1. Switch off the pewag levo clamp
LC. Hold down the on/off
button until the status display on
the battery begins to flash
in intervals. The device is now in
connection mode.
2. On the radio control unit, press
the „status query“ button to
perform the connection process.
When the connection has been
established successfully, the
status display on the battery will
give one long flash. The radio
control unit is now connected.
Section 2 may be repeated for
as many radio control units as
necessary.
3. To end the connection mode,
press the on/off button on the
pewag levo clamp LC again.
This process must be completed
for every pewag levo clamp LC and
every radio control unit.
Please note that one radio control unit
may be connected with several pewag
levo clamps LC (=clamp network, see
chapter 5.5).
Several radio control units may also
be linked to one or several pewag
levo clamps LC.
Button
Description
Open cam
Press this button to open
the cam
Close cam
Press this button to close
the cam
Clamp lighting
button (optional)
Press this button to activate/
deactivate the light module
that is integrated in the
pewag levo clamp LC.
The light will deactivate
automatically after a certain
period of time (depending
on the setting).
Status query
Press this button to receive
a status notification for the
connected pewag levo
clamps LC.
Keylock
+
transmitting signal*
+
power save mode°
A keylock function is
available for the radio
control to prevent accidental
activation of keys. To
lock/unlock the radio
control, briefly press the
lighting and status button
simultaneously. Please
find further settings under
chapter 5.3.
Information
symbols
Description
pewag levo clamp
LC battery charge
display
Shows the charge status of
the pewag levo clamp LC
battery. If only the red LED
lights up, the battery must
be placed in the charging
station
Status display
See description 5.2.
Radio control
battery status
The battery that is integrated
in the radio control is weak
and should be exchanged
soon. For more information,
see chapter 9.7 Exchanging
the battery in the levo
remote radio control.
Radio control
keylock
If this symbol lights up, the
keylock is activated.
Fig. 7: Press to end
Fig. 5: Press for 3 seconds
Fig. 6: Press button „status query“
