33
pewag levo hook
EN
• Non-compliance with the appropriate processes and
procedures
• Modifications of/changes to the pewag levo hook
• Incompetent use of the lifting device and non-compliance
with the instructions outlined in the appropriate manual
• Maintenance or repair works that have been performed by
persons not authorised by pewag
The manufacturer shall not be liable for incidental damages or
damages resulting from misuse of the pewag levo hook or from
violations of these warranty terms and conditions.
11. Storage
Store the pewag levo hook in a clean condition and with the
battery compartment facing downwards. The product must
not be exposed to corrosive, thermal or mechanical influences
during storage. Batteries should be stored fully charged and
separately from the pewag levo hook at room temperature to
increase their lifespan. For long-term storage, we recommend
charging the battery at approx. 40% of its capacity. If the battery
is not used for longer than three months, we recommend
charging it to 40% of its full capacity every three months.
Batteries must be stored in accordance with local regulations.
12. Removal from service
The product has a high metal content and is fully recyclable.
At the end of its lifespan, the product must be recycled in
accordance with local regulations. Special batteries must
be disposed of accordingly. Improper disposal (e.g. by
burning) may lead to poisoning, burns, chemical burns and
environmental pollution.
For all EU countries:
Do not dispose of electrical goods via domestic waste! In
accordance with the European directive on waste electrical
and electronic equipment, such equipment must be collected
separately and recycled in an environmentally friendly manner.
13. Declaration of conformity
- in accordance with Appendix II A of Machinery Directive
2006/42/EC 2010 for lifting accessories:
Representative for the compilation of technical documents in
accordance with Appendix VII, part A:
DI Bernhard Oswald
Mariazeller Straße 143
A-8605 Kapfenberg
We declare under our sole responsibility that the product
for which this operating manual is valid complies with the
regulations
of Directive 2006/42/EC.
The following standards have been applied:
In accordance with Appendix VI of Directive 2011/65/EU on
the restriction of the use of certain hazardous substances
in electrical and electronic equipment:
We declare under our sole responsibility that the product
for which this operating manual is valid complies with the
regulations
of Directive 2011/65/EU of the European Parliament and the
Council from 8 June 2011 on the restriction of the use of certain
hazardous substances in electrical and electronic equipment.
Any modifications carried out on the product that were
not authorised in advance by pewag shall result in these
declarations losing their validity.
Prior to using this product for the first time, the operations
manual must have been read and understood in full.
Graz, 01/09/2017
pewag austria GmbH
ppa. Stefan Duller
ISO 9001
ISO 12100:2010
EN 61000-4-8
EN 1677
ISO 13849-1:2015 EN 61000-6-4
EN 10204 3.1.B
ISO 13849-2:2012 EN 61000-6-2
Machinery Directive
2006/42/EG
EN 55011/22
FCC, 47 CFR Part 15
EN 61000-4-2
EN 300220-2
EN 61000-4-3
IC RSS-247
