Input
60
In the fi rst seam zone
- the number of stitches should be
10
stitches
- the roller presser should work with a feed motion (stitch length) of
2
.
6
mm.
Select the value
2
.
6
for the feed motion (stitch length) of the roller presser.
Switch to the input of the second seam zone.
In the second seam zone
- the number of stitches should be
25
stitches
- the roller presser should work with a feed motion (stitch length) of
2
.
6
mm.
Select the value
2
.
6
for the feed motion (stitch length) of the roller presser.
Switch over to enter the second seam (left seam).
Enter the seam zones of the left seam in the same way as the above-mentioned seam
zones.
Activate the “End program” function.
Conclude the input of the seam program and change to programmed sewing.
Summary of Contents for 1591
Page 77: ...77 13 Table Top 13 01 Tilt base Tilt base 2x rawlplugs ...
Page 81: ...Notes ...
