Set-up and Initial Commissioning
20
8
.01.01
Setting the table height
Loosen the screws
1
.
Move the table top to the desired working height by pulling it out and pushing it in and
align the table top horizontally.
Adjust the stand on both sides evenly to prevent it tilting.
Firmly tighten the screws
1
.
8
Set-up and Initial Commissioning
The machine may only be set up and started up by qualifi ed personnel! All of
the relevant safety regulations must always be complied with in this process!
Adequate stability of the stand must be guaranteed, even during the sewing
operations.
8
.01
Set-up
Suitable electrical and pneumatic supply connections must be provided at the erection site,
see
Chapter 3 Technical Data.
The erection site must have a fi rm and level subsurface and adequate lighting.
The table top is lowered for packaging purposes.
The adjustment of the table height is described below.
Fig. 8 - 01
1
