Page 14
1. Locate the two threaded holes on the left side of the
machine, near the top and towards the middle.
2. Remove the 2 screws. Line up the holes of the
thread stand with the holes on the machine and
reinsert the screws.
3. Turn the thread stand until the eyelets are posi-
tioned over the spool pins.
Installing the Thread Stand
Note:
The eyelets of the thread stand MUST be centered
over the spool pins. This ensures that the cone of thread
will not pull, turn or tilt, which will cause thread tension
problems (see Figure 5).
Figure 5
Installing the Color Touch-Screen
The color touch-screen comes pre-installed on its
mounting bracket and should have one end of the D
cable attached to the back of the touch-screen (see
Figure 6).
Note:
Confirm that the power is turned off before
installing the Color Touch-Screen.
1. Align the holes in the color touch-screen bracket
hinges with the 4 holes on the front of the machine,
with the touch screen facing the needle end of the
machine.
2. Use a Phillips screwdriver to tighten the 4 screws
through the holes of the hinges and into the machine
(Figure 6). Tighten in place.
3. Plug the remaining cable end into the display
connector located on the side of the machine
(page 11, Figure 2, #19).
4. Remove the protective plastic from the touch-screen
before using.
Figure 6
