27
Set Quilt Area:
This is the entire area that can be quilted at any time.
It will ask you to move to the upper left corner of your
quilt area and touch the (+) key, then it will ask you to
move to the lower right and touch the (+) key. It will
then give you the width and the height of your area.
This is to ensure the system knows where your rails are
and doesn’t run into one of them.
a. After setting your quilt area, it will automatical-
ly become the Pattern Box. (see “adjust current” below
for options)
b. If you have not yet set the quilt area and you try
to add a pattern or do a pattern box, you will be re-
quired to set the area fi rst.
Set pattern box:
This is your individual pattern box you are setting. It
may be the same size as your quilt area, it may be a
smaller quilt block.
+
The fi rst 2 points of your pattern box are going to
set what is called a “base line”. This determines
which way your pattern will be inserted into the
pattern box. You need to
ALWAYS
set your
pattern box points counter clock wise.
If you
want your base line to be at the bottom and your
pattern inserted right side up, set the lower left
and right hand points. If you want your baseline
to be at the top and the pattern inserted upside
down, set the baseline at the back right and back
left.
Adjust current:
After you set your quilt area a default pattern box will
appear, you have a few options:
+
Use the Quilt Area as your pattern box and do not
set a new pattern box.
+
Select “Adjust Current” and set a new pattern box.
Summary of Contents for QUILT ARTIST II
Page 2: ...2 ...
Page 15: ...15 ...
Page 16: ...16 Operating PFAFF QUILT ARTIST II ...
Page 42: ...42 ...
