Operating instructions CWB-ATEX
120799 61 616 07 300 0
05/2021
Page 11 / 14
30046-005k
en
8
Commissioning
DANGER
Explosion hazard due to incorrect installation!
Non-compliance results in severe or fatal injuries.
• Check the device for proper installation before commissioning.
• Comply with national regulations.
Before commissioning, ensure the following:
• Check the mounting and installation.
• Inspect enclosure for damage.
• If necessary, remove foreign bodies.
• If necessary, clean the connection chamber.
• Check if the conductors have been inserted correctly.
• Check if all screws and nuts have been tightened firmly
• Check if all drilled holes are closed.
• Check whether all the cable entries and stopping plugs have been tightened firm-
ly.
• Check if all conductors have been clamped firmly.
• Check if the line voltage and the rated operational voltage are consistent.
• Check if the permissible conductor diameter for the corresponding cable entries
have been used.
• Check if the device is closed according to regulations.
9
Operation
9.1 Operation
The beacon series CWB-ATEX provides a visual signal intended to alert, warn or
draw attention to an event.
9.2 Troubleshooting
If an error occurs please re-visit the earlier sections of this document. If the error can-
not be eliminated using the mentioned procedures:
• Contact manufacturing plant, contact data see chapter 1.
For fast processing, have the following information ready:
• Type and serial number of the device
• Purchase information
• Error description
• Intended use (in particular input / output wiring)
