15 685408014B
Operation panel
1. View Parameters
In the home page, press
‖Select‖ for 3s, operation display
shows
―SEE‖, press ‖Select‖ again, using ‖
▲
‖ ―
▼
‖, user
can select following parameters in cycle:
‖pb1‖, ‖t1‖, ‖dor‖,
―IFR‖, ―EFR‖, ―Con‖, ―ALr‖, at any parameter,
press
‖Select‖ again, corresponding value will be shown,
Press
―Mode‖ to go back to previous menu, or wait 5min
to go back to home page.
The codes means see (Appendix I)
2. Parameter setting
• In the home page, into parameters ―t1‖ value, then
press
‖
▲
‖ for 6S, user can press ‖
▲
‖ or ―
▼
‖ to get the
desired value , then p
ress ―Select‖ again to confirm the
change, Press
―Mode‖ to go back to previous menu, or
wait 5min to go back to home page. If no need to
change, just press
―Mode‖ to back to previous menu.
Caution:
·
Normal user only can use „‟T1‟‟, it‟s Internal setting
temperature of the cabinet, other parameters only for
manufacturer using.
·
After resetting, the unit must be return home page.
·
On any parameter interface, press
“Mode” to go back to
previous menu until home page.
·
On any interface, home page will be shown without
pressing any button for 300s.
Caution:
Please set the parameter in the specified range (Appendix
1) and incorrect setting will cause the machine to be
unable to work properly.
12 Cleaning and Maintenance
Hazard!
Please cut off the cooling unit‟s power before carrying out
any cleaning or maintenance operation.
12.1 Cleaning
The cooling unit is to achieve the maximum possible free
maintenance in the correct using condition, that is mean
no need for regular inspection and maintenance.
It will be improved the operation efficiency and reliability of
the equipment if there are conditions for the periodic
cleaning of the condensate.
Pay a special attention to the following instructions.
•Clean the pipe of the external fan, condenser and the
external fan.
•Work with a soft brush or high pressure air.
Proceed as follows:
1) Cut off the cooling unit‘s power.
2) Remove the external cover.
3) Clean the fan pipe.
4) Clean the external fan.
5) Clean the exchangers.
6) Put in back the external cover
7) Connect the power and observe the self-check function
to make sure the equipment is running properly.
Caution:
Protect the electric components against
leakage
Caution: Protect the heater exchanger to
damage
Don‟t use any pointed or Sharp-edged objects.
Caution: To prevent the damage to the
electrical connection on the covering hood.
If the covering Hood is removed, the eclectic
plug-in connections on the inside must be removed
by hand.
Light
Description
Lighting
Flash
Self-check
Self-check
-----
Cold
Cooling
-----
Heat
-----
-----
Huminity
-----
-----
Fan
Running
-----
Alarm
Alarm
-----
