Operating Instructions
AS700 PRESSURE SEALER
Page 16
SECTION 10
ERROR MESSAGES
If operating faults occur, an error code will appear on the control panel display, for example:
where 'No' = one of the numbers
indicated below.
ERROR No.
MEANING
ACTION TO TAKE
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25,26,27 or 28
29
See note at end.
See note at end.
See note at end.
Check for jam, see note at end
Diverter stuck - call Service.
Empty tray.
See note at end.
See note at end.
See note at end.
Empty tray.
See note at end.
See note at end.
Clear all paper, recalibrate.
See note at end.
See note at end.
Open cover and clear double
Hopper empty.
Paper jam at infeed.
Form didn't arrive at fold plate 1.
Paper jam at fold plate 1.
Unexpected form at fold plate 1.
Fold plate 1 blocked.
Form lost from fold plate 1.
Form didn't arrive at diverter.
Jam in divert tray.
Unexpected form at diverter.
Divert tray full.
Paper jam in fold rollers.
Paper jam in fold plate/rollers.
Unexpected form at fold sensor.
Form lost in fold plate/rollers.
Fold sensor blocked.
Possible jam in sealer rollers.
Receiving tray full.
Unexpected form at eject area.
Jam in sealer rollers.
Eject sensor blocked.
EPROM error.
Double document error.
Motor/clutch problem.
Lost document.
Undiverted double (too long).
Note: if any of these error numbers occur, remove all paper from the machine and clear any
jams (
), reload the paper and run the machine
again. If the fault still occurs, contact the Service Department. The messages 'COVEr' and
'FPOUt' may also occur, indicating cover open or fold plate removed.
Issue 1 Apr 2002
