WARNING
Risk of serious injury due to falling objects
When transporting parts/items by hand, there is a danger of loads slipping and falling down.
► Carry small and medium-size parts/items with two hands.
► Wear safety shoes with steel toe according to directive EN 347.
WARNING
Risk of burns in case of contact with hot surfaces
For the operator’s safety, the products are designed to avoid thermal risk. However, specific operat-
ing conditions may exist that require extra caution on the part of the operator due to the high temper-
atures (surfaces > 70 °C for parts inside the cover(s)).
► Wait for the product to fully cool down before working on it.
► Protective gloves must be worn in accordance with standard EN 420.
CAUTION
Risk of crushing related to product tilting
Although the product fully complies with EEC safety regulations, there is a risk of tilting when the
product is not correctly installed or used.
► Place the product on a flat, hard floor.
► Keep the product on its 4 feet.
CAUTION
Risk of pinching when handling the storage box cover
► Be careful not to leave your fingers under the cover when closing.
DANGER
Health hazard in case of contact with components contaminated
The components of the pumping circuit and the analyzer cell are contaminated with the gases pump-
ed through the tested parts. These gases may be toxic, corrosive and/or reactive. Any contact with
the contaminated parts or by-products generated by the process may be injurious to health.
► Wear appropriate protective equipment when performing maintenance on the components of the
pumping line, vacuum block and analyzer cell.
► Ventilate the area thoroughly or carry out the maintenance under an extraction hood.
► Do not eliminate the by-products/residue as common waste; have them destroyed by a qualified
company where necessary.
WARNING
Poisoning risk in case of gas leakage after maintenance
When connecting/disconnecting pumping line components (pumps, analyzer cell, vacuum block, pi-
pework, valves, etc.) for maintenance, the tightness of the installation is broken, potentially causing
leakage of hazardous residual gases (pumped gases for parts to be tested).
► During disassembly, always protect the bearing surfaces of the connecting flanges between the
pumping line components.
► After reassembly, perform a tightness check on the pumping line of the detection system.
2.1.2 Precautions
Duty to provide information on potential dangers
The product holder or user is obliged to make all operating personnel aware of dangers
posed by this product.
Every person who is involved in the installation, operation or maintenance of the product
must read, understand and adhere to the safety-related parts of this document.
Safety
8/30
