24
www.pfisterer.com
Drawings not to scale - for information only Size 3 | 3-S / Standard instructions wire screen / No. 040 371 001 (2014-05-08) i-01
Crimping tool no.
Chapter 5.4, page 13.
85
Installation / Assembly
VIII
20
1
Only with strippable semi-conductive layer
Wrap semi-conductive tape tightly, a straight edge is requi-
red at the front. Tear off the remainder of the semi-conduc-
tive tape. The edge of the strippable semi-conductive layer
must be sealed.
Only with fine wire stranded conductor
Stretch self-amalgamating semi-conductive tape lengthwise over
approximately half the length and cut off the end. Apply the 20 mm
semi-conductive tape with a 50 % overlap.
25
1
Slide the first compression sleeve onto the conductor with a 10 mm
spacing from the insulation. Perform a round crimping operation with
suitable tools.
26
1
Slide the second compression sleeve onto the conductor with a 10 mm
spacing from the insulation. Perform a round crimping operation with
suitable tools.
27
1
Saw off the conductor with the crimped-on sleeve 85 mm and then de-
burr the sleeve.
28
1
Summary of Contents for MV-CONNEX 3
Page 2: ...2 www pfisterer com...