PFT G 54 E
Operating Instructions
09/2006
Knauf PFT GmbH & Co.KG
28
Transport
First pull the main power cable and then undo all other power connections.
Remove the water supply lines.
The
G 54
E
consists of two units (mixing tube and material hopper), which can be transported
separately.
WARNING!
Make sure all hoses are depressurised before opening the couplings
(observe the mortar pressure gauge display).
Maintenance
The water inlet filters in the pressure reducer should be taken out and
cleaned at least once every two weeks and replaced if necessary.
Check the brass water inlet filter every day.
Beat the dirt out of the compressor filter once a week, depending on
operation.
Replace the filters if they are very dirty.
Note:
The coarse side of the filter should be on the inside!
