Mixing pump RITMO L / RITMO M Overview - Operation
Apply mortar
42
2016-02-17
NOTE!
It is also possible to operate the machine without
compressed air, e.g. for pouring screed. Switch off
air compressor and work without spraying gun. The
machine is then switched on and off via an optional
remote control cable.
35.2 Interruption of work
NOTE!
Always observe the setting time of the material to be
processed:
Clean the system and mortar hoses depending on
the setting time of the material and the length of the
interruption (pay attention to outside temperature).
The guidelines of the material manufacturers have to
be observed regarding breaks.
1
Fig. 63: Closing the air tap
1. Close the air tap (1) if you interrupt your work for a short while.
2. The machine stops.
3. Once you open the air tap (1), the machine will start-up again.
35.3 In case of longer interruption of work/break
1
Fig. 64: Closing the air tap
Fig. 65: Switching off
1. Close air tap (1).
2. Turn the selector switch (2) to the “Null” position towards the
left.(centre position).
2
2
