HOT WIRE CUTTING TOOL Overview - Operation - Spare parts lists
Work for rectifying faults
29.07.2013
Page 21
8 Work for rectifying faults
8.1 Reaction in the event of faults
Reaction in the event of faults
The following strictly applies:
1. In the event of faults presenting immediate danger to persons
or property, activate the emergency OFF function immediately.
2. Determine cause for fault.
3. If the rectification of faults requires works in the danger zone,
switch off the tool and secure against restarting.
4. Inform the manager on site immediately about the fault.
5. Depending on the type of fault commission authorised skilled
personnel or rectify the fault yourself.
NOTE!
The following fault table gives information on who
is authorised to rectify the fault.
8.2 Faults
The following chapter describes possible causes for faults and the
activities carried out for their rectification.
In case faults occur frequently, shorten the maintenance intervals
in accordance with the actual load.
In the event of faults that cannot be rectified by means of the
following notes, kindly contact the dealer.
8.3 Safety
Personnel
The work for rectification of faults described here can be carried
out by the operator, unless marked otherwise.
Some works must be carried out only by specially trained skilled
personnel or exclusively by the manufacturer. Information on
this can be found in the description of the individual faults.
Work on the electrical system must, in principle, be carried out
only by electricians.
Personal protective gear
The following protective equipment has to be worn for all
maintenance work:
Protective goggles, protective gloves, safety shoes, ear
protection.
