HOT WIRE CUTTING TOOL Overview - Operation - Spare parts lists
Examples for using CUTMASTER
29.07.2013
Page 29
16
Examples for using CUTMASTER
Fig. 5: Overlap cuts
16.1 Overlap cuts
Using the storage screw for the depth stop on the cutting
bow, cuts for wall projections or overlaps can be easily
achieved.
Fig. 6: Cuts
16.2 Cuts
Cuts for cable ducts or drainage pipes can be easily made
using the storage screw for the depth stop.
Fig. 7: Mitre cuts
16.3 Mitre cuts
The cutting bow can be adjusted variably to any position.
For easy handling, the cutting bow locks at 45° and at 90°.
NOTE!
Ensure that the knurled screws are loosened above
and below on swivelling the main bow, otherwise the
ball slide rails while unnecessarily be burdened.
