HOT WIRE CUTTING TOOL Overview - Operation - Spare parts lists
Preparation
29.07.2013
Page 39
22.8 Stop screw for cutting depth
Fig. 28: Stop screw
Using the stop screw (1) on the cantilever of the swivelling unit, you
can set certain cutting depths.
Pull out the main cutting bow (2) to the desired cutting depth and
lock using the stop screw (1) on the upper and the lower cantilever.
The set cutting depth can be read on the left of the stop screw on
the arrow.
22.9 Storage screw for depth stop
Fig. 29: Storage screw
Fig. 30: Cut-out
Storage screws (1) are installed in each
case on top and bottom of the swivelling
unit, with which the cutting depth of the
cutting bow (2) can be restricted.
Cuts with the same depth can be repeated
in this way.
22.10 Storage screw for swivel unit
Fig. 31: Storage screw
Fig. 32: Cut
The angle of contact of the cutting wire in
the material can be changed by adjusting
the main cutting bow (1).
••••
Loosen the knurled screws (2) at the
bottom and on top on the swivelling unit
and set to the required angle.
••••
Locking points are at -45°/90°/+45°.
••••
Tighten knurled screws again.
The angle required for a project can be set
with the storage screw (3). In the meantime,
desired further steps can be carried out, in
order to return to the default angle.
1
2
3
1
2
1
2
