HOT WIRE CUTTING TOOL Overview - Operation - Spare parts lists
Commissioning the PFT CUTMASTER
Page 40
29.07.2013
23 Commissioning the PFT CUTMASTER
23.1 PFT CUTMASTER cutting process
Fig. 33: On/Off button
By pressing the red press button (1) on the cutting bow, the cutting
wire heats up to the optimum temperature within two seconds.
NOTE!
The press button must be pressed ad held down
during the cutting process.
Press the cutting wire into the material slowly and
with appropriate pressure.
DANGER!
Danger of injury due to the hot cutting wire.
While cutting, keep one hand on the cutting bow
(press button) and the other hand on the material
that has been cut, away from the path of cutting of
the cutting wire.
Warning!
Always use the tool only in well-ventilated working
areas.
Avoid inhaling the vapours released from cutting of
materials.
23.2 PFT CUTMASTER with cutter for rafters
Turn the On/Off button 5 on the cutting bow 1 to position “I” to
activate the main cutting wire. Press the red On/Off button on the
cutting bow 1 with the right thumb to heat up the cutting wire. Cut
with the right hand using the cutting bow and hold the material that
has been cut with the left hand away from the path of cutting, in
order to avoid injuries. You can now cut conventional foam
polystyrene panels by moving the cutting bow.
1
