HOT WIRE CUTTING TOOL Overview - Operation - Spare parts lists
Change the cutting wire
29.07.2013
Page 43
25 Change the cutting wire
25.1 Secure against restarting
DANGER!
Danger to life from unauthorised restarting!
When working with the tool, there is the risk that
the energy supply is switched on without
authorisation. This poses a danger to life for the
persons in danger area.
••••
Switch off all power supplies before starting any
work and secure against restarting.
••••
Pull out the mains plug.
Electrical system
DANGER!
Danger of death from electric current!
There is danger to life if you come in contact with
live parts. Activated electrical components can
carry out uncontrolled movements and cause
serious injuries.
Therefore:
••••
Switch off the energy supply before starting any
work and secure against restarting.
25.2 Spare cutting wire
Fig. 35: Spare cutting wire
There is a 10 meter roll of spare cutting wire on the rear of the PFT
CUTMASTER (optional 20 meters of cutting wire. Article
number 00257135).
••••
Article number 00257134 wire on a 10m roll for CUTMASTER.
••••
Article number 00257135 wire on a 20m roll for CUTMASTER.
25.3 Cutting wire storage above
Fig. 36: Storage above
Approx. Cut 140 cm of cutting wire from the spare roll.
Guide the cutting wire over the brass roll (1) and hinge the twisted
end on the spring-loaded hook (2).
1
2
