HOT WIRE CUTTING TOOL Overview - Operation - Spare parts lists
Maintenance
Page 44
29.07.2013
25.4 Cutting wire storage below
Fig. 37: Storage below
Guide the cutting wire through the eyelet (1) and tighten with
appropriate force, in order to tension the spring on the upper wire
storage.
Twist the end of the wire.
NOTE!
No part of the wire must remain on the tool.
Cut out all protruding extra wire parts, as these can
cause a short-circuit between the hook and the bow.
26 Maintenance
26.1 Safety
Personnel
Some maintenance work must only be carried out by specially
trained technical personnel or exclusively by the manufacturer.
Work on the electrical system must, in principle, be carried out
only by electricians.
Electrical system
DANGER!
Danger of death from electric current!
There is danger to life if you come in contact with
live parts. Activated electrical components can
carry out uncontrolled movements and cause
serious injuries.
Therefore:
– Switch off the energy supply before starting any
work and secure against restarting.
Basic information
WARNING!
Risk of injury due to improperly carried out
maintenance work!
Improper maintenance can lead to severe injuries
or considerable property damage.
– Prior to starting the works ensure that there is
enough space to carry out the works.
– Ensure order and safety at the assembly site!
Loose, stacked components or components
lying about can cause accidents.
– If components were removed, ensure proper
assembly, put back all fastening elements and
observe torque indications for screws.
– After every maintenance or repair, ensure that
all protection equipment has been correctly fixed
before the machine is re-commissioned.
1
