PFT ZP 3 L MULTIMIX Overview – Operation – Spare Parts Lists
Interruption of work
34
2016-07-04
31.9 Changing the motor speed on the ZP 3 L
Fig. 53: Changing the speed
The material quantity for spraying can be regulated by changing
the speed using the hand wheel (1) of the gear motor.
NOTE!
Do not adjust the Vario gearbox of the ZP 3 L when
the machine is at a standstill, but only when it is
running. The machine should also not be operated at
one motor speed all the time, as otherwise the v-belt
pulleys wear down too fast.
31.10 Working without air
Fig. 54: Remote control
NOTE!
If work is done without air (e.g. when pumping screed),
the machine is switched on and off by a 42 V remote
control coupling. To do this, the dummy plug (1) must
be removed from the coupling and the remote control
plug (2) must be connected.
32 Interruption of work
Fig. 55: Closing the air valve
1. Close the air valve (1) on the spraying gun.
2. The machine stops.
3. By opening the air valve (1), the machine will start running
again.
32.1 In the event of prolonged work stoppages
2
1
Fig. 56: Switching off
1. Press the red push button (1) to switch the control voltage
“OFF”.
2. Switch off the machine at the main reversing switch (2).
NOTE!
Generally, the setting times of the materials to be
processed must be observed:
Clean the equipment and hoses as appropriate for
the setting time of the material and the length of
the interruption (take outdoor temperature into
account).
Observe
the
guidelines
of
the
material
manufacturer regarding interruptions.
2
1
1
