SWING M delivery pump / Part 2 Overview, operation and service
Operation
5.12.4
Disconnecting and cleaning the mortar hose
2
1
Figure 43: Disconnecting the water
hose
Disconnecting the water hose
1. Check the mortar pressure gauge (1) to determine whether the
mortar pressure has fallen to "0 bar".
WARNING
Overpressure on the machine!
When opening machine parts they can open in an uncon-
trolled manner and injure the operator.
Only open the machine if the pressure has fallen to 0
bar.
2. Loosen the cam lever (2) and decouple the mortar hose from the
mortar pressure gauge.
2
1
3
4
Figure 44: Cleaning the mortar hose
Cleaning the mortar hose
NOTE
The mortar hoses and spray gun must be cleaned imme-
diately at the end of work.
1. Connect the cleaner coupling (1) to the water tap (2).
2. Press the water saturated sponge ball (3) into the mortar hose (4).
3. Connect mortar hose (4) with the sponge ball to the cleaner
coupling (1).
4. Unscrew the nozzle from the spray gun.
5. Open the water tap until the sponge ball emerges at the end of the
spray gun.
6. Repeat this procedure several times in case of heavy soiling.
7. In case of different hose diameters, the mortar hoses have to be
cleaned separately with the corresponding sponge balls.
5.12.5
Cleaning the spray gun
1
3
2
Figure 45: Cleaning the spray gun
1. Remove the mortar hose from the spray gun (1).
2. Unscrew the nozzle from the spray gun.
3. Insert water-soaked sponge ball (2) into the spray gun.
4. Connect the water hose (3) to the spray gun (1).
5. Open the water tap until the sponge ball emerges at the end of the
spray gun.
6. Repeat this procedure several times in case of heavy soiling.
page 35 / 52
