Mixing pump RITMO XL FC-230/400V / Part 2 Overview, operation and service
Description
4.3
Fields of application
For pumpable pre-mixed dry mortar such as:
gypsum plasters
lime/gypsum plasters
Cement plasters
lime plasters
fango material
insulation plasters
filling plasters
armour and glueing mortar
floor screed
Masonry mortar
.... and much more
Flowability / flow characteristics
The pump unit D 6–2 L can be used up to 20 bar oper-
ating pressure.
The SD 6–3 SLIMLINE pump unit can be used up to
25 bar operating pressure.
The pump unit D 4–3 can be used up to 30 bar oper-
ating pressure.
The possible conveying distance depends mainly on
the flowability of the material.
If 20, 25 bar or 30 bar operating pressure are
exceeded the mortar hose length has to be reduced.
To avoid machine breakdowns and excessive wear on
pump motor, mixing shaft and pump, always use orig-
inal PFT spare parts such as:
– PFT rotors
– PFT stators
– PFT mixing shaft
– PFT mortar hoses
These are compatible with each other and form a
constructive unit with the machine.
Non-compliance does not only cause loss of guar-
antee, but also bad mortar quality is to be expected.
4.4
Description of assemblies
The PFT RITMO XL mixing pump consists of the main components
described in the following chapters.
page 22 / 76
