Mixing pump RITMO XL FC-230/400V / Part 2 Overview, operation and service
Operation
5.3.8.3 Switching on the air compressor
1
Figure 48: Switching on the air
compressor
1. Turn the air compressor selector switch (1) to the "1" position.
It is also possible to operate the machine without
compressed air, e.g. for pumping screed. To do this,
switch off the compressor at the selector switch and
operate the machine without the sprayer.
Connect the remote control cable and use it to switch the
machine on/off.
5.3.9
Feeding dry material to the machine
Figure 49: Bagged goods
Loading with bagged goods
Depending on the equipment, the machine can be fed with bagged
goods, with the delivery hood or the injection hood.
CAUTION
Danger of injury at the sack opener!
The sharp edges of the sack opener pose a risk of injury.
Wear safety gloves.
For initial filling with bagged material slowly pour half of
the first bag into the material hopper!
Figure 50: Delivery hood
Feeding with delivery hood
Item no. 00201620
WARNING
Do not open the delivery hood during the operation of
the machine.
Before opening, turn off the master switch/main
reversing switch and interrupt the power supply.
NOTE
First feed material to the mixing pump RITMO XL. Pull
the dummy connector or switch off the machine using
pressure control air. Start your work only when the level
sensor indicates full.
page 41 / 76
