Mixing pump RITMO XL FC-230/400V / Part 2 Overview, operation and service
Operation
5.8
Interruption of work
NOTE
Always observe the setting time of the material to be
processed:
Clean the system and mortar hoses depending on the
setting time of the material and the length of the interrup-
tion (pay attention to outside temperature).
The guidelines of the material manufacturers have to be
observed regarding breaks.
1
Figure 61: Closing the air tap
1. Close the air tap (1) if you interrupt your work for a short while.
The machine stops.
By opening the air tap (1), the machine will start running again.
5.8.1
In case of longer interruption of work / break
NOTE
Always observe the setting time of the material to be
processed:
Clean the system and mortar hoses depending on the
setting time of the material and the length of the interrup-
tion (pay attention to outside temperature).
The guidelines of the material manufacturers have to be
observed regarding breaks.
1
Figure 62: Closing the air tap
1. Close the air tap (1) if the work is interrupted for an extended
period of time.
page 47 / 76
