LOTUS XS 230 V horizontal continuous mixer / Part 2 Overview, operation and service
Operation
3
3
Figure 39: Removing the mixing tube
2. Hold the mixing tube by the two holders (3) and turn it to the left.
3. Remove the mixing tube with the mixing shaft by pulling it forwards.
CAUTION
Danger of crushing due to the mixing tube!
Note the weight of the mixing tube when removing and
installing it.
5.12.3.1 Cleaning the mixing tube and mixing shaft
1
2
Figure 40: Cleaning the mixing tube
and mixing shaft
1. Thoroughly clean the mixing tube (1) and mixing shaft (2).
2. If there is residual dry material in the material hopper, this should
only be cleaned on the outside using a brush or a dry cloth.
3
4
Figure 41: Cleaning the rubber mixing
tube
3. The rubber mixing tube can be dismantled for cleaning.
4. To do this, pull the rubber mixing tube (3) out of the holder for the
rubber mixing tube (4) and clean it thoroughly.
page 34 / 48
