Safety - Service Manual - Spare Part Lists
Setting the Sawing Unit (Longitudinally, Transversely and
Five-fold)
2011-04-07
16
12.) Lightly screw in the screws (not
tighten).
13.) Check the slide with angle and
tighten the screws (tighten with
care and tighten again).
14.) Tighten the two Allen screws
of the guide rail.
9 Setting the Sawing Unit (Longitudinally, Transversely and
Five-fold)
9.1 Checking and setting the cutting angle for the sawing units
Figure: 3.1.1
Lay a gypsum board with approx. 40 x 30 cm on the
cutting table and attach the stop limit strips. [Figure:
3.1.1]
Attach the gypsum board on the stop limit strips.
