Safety - Service Manual - Spare Part Lists
Setting the Sawing Unit (Longitudinally, Transversely and
Five-fold)
2011-04-07
17
Figure: 3.1.2
Fix the transverse axis at approx. 10 cm from the
stop limit. [Figure: 3.1.2]
Figure: 3.1.3
Figure: 3.1.4
Figure: 3.1.5
On the left side of the plate fix also the longitudinal axis (both brakes are fixed), [Figure: 3.1.3] Switch on the
swing unit and cut into the gypsum board once with the sawing unit. (The sawing unit should be lowered
very slowly and for machines with hydraulic lifting equipment, this should occur manually.) [Figure: 3.1.4]
Now switch off the unit and raise it, [Figure: 3.1.5] Loosen the longitudinal axis (the transverse axis remains
fixed) and traverse with the equipment head rightwards.
Figure: 3.1.6
Between the slides there should be a gap of approx.
2-4 cm. [Figure: 3.1.6]
