Safety - Service Manual - Spare Part Lists
Setting the Sawing Unit (Longitudinally, Transversely and
Five-fold)
2011-04-07
18
Figure: 3.1.7
Again fix the longitudinal axis (both brakes are fixed)
switch on the sawing unit and now on the right side
cut once with the sawing unit into the gypsum board.
(The sawing unit should be lowered very slowly and
for machines with a hydraulic elevating equipment,
this should occur manually.) Switch off the unit and
raise it. [Figure: 3.1.7]
Figure: 3.1.8
Figure: 3.1.9
Now a line is drawn along the two
cuts [Figure: 3.1.8] and checked
whether the two cuts are aligned.
[Figure: 3.1.9]
Should the cuts not be aligned as shown on the sketch, [Figure: 3.1.10 and 3.1.11] the sawing unit must be
set as follows.
Figure: 3.1.10
The left screws have to be set.
Figure: 3.1.11
The right screws have to be set.
Attention!
When you carry out tasks on the units, switch off the main switch of the machine
and detach the machine by pulling out the mains plug.
Never lift the units by the tools (saw blades or mills) nor touch under them.
(Danger of being cut!) After terminating the setting tasks on the units and
removing all tools from the working area, the machine should be switched on
again.
