Safety - Service Manual - Spare Part Lists
Setting the Sawing Unit (Longitudinally, Transversely and
Five-fold)
2011-04-07
19
For this, on one side [side to be set, Figures: 3.1.10 or 3.1.11] the two external nuts are loosened (both
equally much) [Figure: 3.1.12 / 1 + 2] and afterwards the internal nuts are tightened. [Figure: 3.1.12 / 3+4].
Figure: 3.1.12 / 1
Figure: 3.1.12 / 2
Figure: 3.1.12 / 3
Figure: 3.1.12 / 4
Figure: 3.1.13
Now the test with the cuts has to be repeated and if
necessary, the screw nuts adjusted anew until the
cuts are aligned as depicted on the sketch. [Figure:
3.1.13].
Figure: 3.1.14
Using the same method,
also the transverse sawing
units must be checked and set. [Figure: 3.1.14]
