Safety - Service Manual - Spare Part Lists
Setting the Sawing Unit (Longitudinally, Transversely and
Five-fold)
2011-04-07
21
9.3 Checking and setting the inclination angle on the sawing units
For this you use a gypsum board that is up to 40 mm thick or a mineral fibre board and fix the transverse or
longitudinal axis and with the transverse or longitudinal saw at least make a 20 cm long cut into the material.
Afterwards, switch off the unit and raise it.
Now check as shown on the sketch the cutting angle of the cut board with an angle. [Figure: 3.3.1]
Figure: 3.3.1
The bottom screws have to be set.
Figure: 3.3.2
The bottom screws have to be set.
Should the cutting angle as shown on the upper sketch be incorrect, then the cutting angle must be
adjusted by means of the two upper and the two lower screw nuts. For this, the sawing unit is removed from
the machine head and on the upper or lower side (depending on which side the cutting angle is incorrect),
first the two outer nuts are loosened (both equally) [Figure: 3.3.3 / 1 + 2] and afterwards the inner nuts are
tightened. [Figure: 3.3.3 / 3 + 4]
Figure: 3.3.3 / 1
Figure: 3.3.3 / 2
Figure: 3.3.3 / 3
Figure: 3.3.3 / 4
Gypsum or mineral fibre
board
Angle
