FERRO 100 II Part 2 Overview – Operation - Spare parts lists
Set up silo with Ferro
26
2018-03-26
Basic information
WARNING!
Danger of injury due to incorrect operation!
Improper operation may lead to serious damage to
persons or property.
Therefore:
Carry out all operating steps according to the
instructions in this user manual.
Prior to starting your work, ensure that all covers and
protection devices are installed and work as intended.
Never deactivate protection devices during operation.
Ensure order and cleanliness in the work area! Loose
components and tools on top of one another or lying
about pose potential accident risks.
Increased noise level may cause permanent hearing
deficiencies. At close range of the machine 95 dB(A)
can be exceeded due to operational conditions. Close
range is a distance of less than 5 metres to the
machine.
19 Set up silo with Ferro
Fig. 21:
Set up silo
DANGER!
Danger of accident due to tilting silo!
Set up the silo / container with the machine in a stable
position on a flat and firmly secured surface.
It must be ensured that the ground cannot yield due to
the load on the silo and that the silo can therefore not tip
over.
Set up the machine in such a way that it cannot be hit by
falling objects.
The operating elements have to be freely accessible.
20 EMERGENCY OFF push button
Fig. 22: EMERGENCY OFF push
button
NOTE!
Every day before starting work, check the EMERGENCY
STOP push button.
–
Activate main switch.
–
Control voltage “ON”.
–
Activate EMERGENCY OFF push button.
The control voltage is switched off by pressing the
EMERGENCY STOP push button!
