FERRO 100 II Part 2 Overview – Operation - Spare parts lists
Inspection
2018-03-26
7
2 Inspection
2.1 Inspection by machine operator
Prior to each shift, the machine operator has to examine the effectiveness
of the control and safety devices as well as the proper fitting of the
protection devices.
The safe working condition of construction machinery has to be checked by
the machine operator during operation.
If the safety devices show any defects or if any other defects are detected
that compromise a safe operation, the supervisor has to be informed
immediately.
In case of defects that cause harm to persons, the operation of the
construction machine has to be stopped to eliminate the defects.
3 Periodic inspection
Construction machinery has to be inspected for their safe working condition
in accordance with the operating conditions and the operational
requirements as needed, however at least once a year by an expert.
Pressure vessels have to undergo the prescribed expert inspections.
The inspection results have to be documented and kept at least until the
next inspection.
Inspection recommendations for the annual expert inspection of the FERRO 100 II (which is to be conducted
in accordance with BGR 183) can be found in this section.
https://www.pft.net/de/service/downloads/index.php?t=0&p=12&s=0&q
4 Accessories
For recommended accessories/equipment, see PFT machines and device catalogue or under
