Mixing pump G 4 X Super / G 4 X XL / Part 2 Overview, operation and service
Operation
5.8.1
In case of longer interruption of work / break
NOTE
Always observe the setting time of the material to be
processed:
Clean the system and mortar hoses depending on the
setting time of the material and the length of the interrup-
tion (pay attention to outside temperature).
The guidelines of the material manufacturers have to be
observed regarding breaks.
1
Figure 55: Closing the air tap
1. Close the air tap (1) if the work is interrupted for a longer period of
time.
2
Figure 56: Switching off the machine
2. Switch off the machine by pressing the red pushbutton (2) control
voltage "OFF".
5.9
Switching off the air compressor
1
Figure 57: Switching off the air
compressor
1. Switch off the air compressor at the red switch (1).
2. Open air tap on the spray gun so that the residual pressure can
escape.
WARNING
Danger of injury from discharged mortar!
Discharged mortar may lead to injuries to eyes and face.
Beware of residual pressure.
page 42 / 72
