PFT SCREW MIXER HM 24 Overview – Operation – Spare Parts Lists
Basic Saftey Instructions
14
2017-08-07
10 Basic Saftey Instructions
1.
Follow all safety instructions on the machine. Ensure that all instructions are legible
2.
Inspect the machine once every shift for visible damages and defects. Stop operating
the machine immediately if you notice any changes in safety or operating behavior.
Notify a supervisor immediately.
3.
Do not make any changes to the machine that can jeopardize its safety. Always
consult the machine dealer first. Do not tamper with the machine by equipping it with
extra "safety devices."
4.
All spare parts must conform to our technical specifications. Only use spare parts
manufactured by PFT.
5.
Only trained personnel should operate the machine. Clearly designate all lines of
responsibility for operation, equipping maintenance and repairs.
6.
Technicians undergoing training in the operation of the machine should be
supervised by experienced personnel.
7.
Only qualified personnel should work on the machine's electrical system. All
electrical work should only take place under the supervision of a qualified electrician
and should comply with electro-technical safety regulations.
8.
Observe all instructions for switching the machine on and off. Watch display lamps
for signals.
9.
When the machine is completely switched off for maintenance and repair work,
ensure that it cannot switch back on accidentaly. Do this by switching off the main
switch,
removing the key or by attaching a warning sign to the main switch.
10. Before cleaning the machine with a water jet, seal all openings that can be damaged
through water, e.g. electrical motors and control boxes, thoroughly. After cleaning
remove all seals and covers.
11. Use only original fuses with prescribed amps.
12. If work has to be carried out on a voltage-conducting component, a second technician
should stand by to switch off mains in case of an emergency.
13. Disconnect the machine from the mains before you move it, even if you are only
moving it a short distance. Reconnect the machine to the mains properly before
starting up again.
14. Set up the machine on stable ground. Secure it from rolling away or moving during
operation.
15. Depressure all conveying systems before dismantling them.
16. Have the machine inspected at once a year by a qualified person. The machine
should also be inspected otherwise as required.
