PFT JETSET pro in case Safety - Overview - Operation - Spare parts lists
Interruption of work
28
2017-10-10
22 Interruption of work
NOTE!
Always observe the setting time of the material to be
processed:
Clean the system and mortar hoses depending on
the setting time of the material and the length of the
interruption (pay attention to outside temperature).
The guidelines of the material manufacturers have to
be observed regarding breaks.
23 Clean the spraying gun
23.1 Disconnect the mortar hose
The spraying gun has to be cleaned daily after work and before
longer breaks.
2
1
Fig. 11: Mortar pressure to "0".
1. Switch off the machine.
2. Check the mortar pressure gauge (1) if the mortar pressure has
lowered to "0 bar".
DANGER!
Overpressure on the machine!
When opening machine parts they can open in an
uncontrolled manner and injure the operator.
Open machine only when the pressure is at "0
bar".
3. Loosen the cam lever (2) and de-couple the mortar hose from
the mortar pressure gauge (1).
NOTE!
Mortar hoses and spraying device have to be
cleaned immediately after finishing work.
