28.01.2019
Page 23
4.3 Removing the packaging
Fig. 3: Packaging
Machine with tank with capacity up to 50 litres:
No special device is required to move the packaging. To lift, grasp the slots in
the carton with your hands. Put on protective gloves and use scissors or pliers
to cut the strapping of the box. Use the pliers to remove the metal clamps,
if present. Open the upper tabs, carefully lift out the compressor and place it
on the work surface. For compressors with a capacity of more than 25 litres,
this should be done by two persons.
Machine with tank over 50 litres capacity:
Using protective gloves and scissors, cut the strapping and pull the carton off
the top of the machine.
Lift the compressor using a lifting device with a suitable load capacity
(see table “Technical data”).
Fit the wheels or vibration dampers.
Pay attention to the enclosed accessories and check that the compressor is
undamaged.
4.4 Disposal of packaging
The packaging material should be stored in a suitable place for possible future transport or at least for
the duration of the warranty period. This facilitates the dispatch to the service point in case of need.
Later, please hand over the packaging to the company or authority responsible for disposal.
Summary of Contents for LK 402 IV
Page 35: ...28 01 2019 Page 35...
