PFT Horizontal Screw Mixer LOTUS XS Overview – Operation
Adjusting the height of the support feet
22
2019-11-07
20 Adjusting the height of the support feet
Fig. 26: Height adjustment
The height of the machine can be adjusted:
Press stand spring (1) and adjust the machine to the respective
height (880mm or 1020mm).
20.1 Mains voltage connection
Fig. 27: Electrical connection
1. Only connect the machine (1) to 230-volt AC current.
DANGER!
Danger of death due to electric current!
The electrical connection must be fused
correctly:
Only connect the machine to a power
source with an approved FI circuit breaker
(30 mA) RCD (residual current device) of
type “A”.
20.2 Water supply connection
Fig. 28: Water inlet screen
1. Check whether the dirt trap sieve in the water inlet (1) is clean.
2. Check that the strainer in the water inlet (2) the water pump is
clean.
3. If necessary, remove the dirt trap sieve from the water inlet and
clean it.
Dirt trap sieve for Geka coupling:
Item number 20152000
4. Clean and bleed the water hose for the water mains supply.
5
4
3
Fig. 29: Water connection
5. Connect the water hose (3) to the water inlet (4) or booster
pump.
6. Check whether the water hose (5) is connected to the middle
body water inlet.
NOTE!
Only use clean water that is free of particulates. The
minimum pressure is 2.5 bar when the machine is
running.
1
1
2
