Part 2 EC Declaration of Conformity Overview – Operation
Mortar hose
2020-03-25
41
45 Mortar hose
45.1 Prepare mortar hose
Fig. 73: Prepare mortar hoses
1. Connect the Cleaner coupling (1) to the water tap (2)
2. Connect mortar hose (3) and water it.
3. Remove the mortar hose and the cleaner coupling again.
4. Empty the mortar hose completely of water.
5. Pre-lubricate the mortar hose with wallpaper paste.
6. The wallpaper paste will be pumped through the mortar hose
with the first mixture.
DANGER!
Never loosen hose couplings as long as the mortar
hoses are not depressurized (check mortar
pressure gauge)! Mixing material could escape
under pressure and cause serious injury, especially
to the eyes.
Torn off hoses can knock around and injure
bystanders!
45.2 Connect mortar hose
Fig. 74: Connect mortar hose
1. Connect the mortar hose (1) with the mortar pressure gauge
(2).
NOTE!
Make sure that the couplings are connected
cleanly and correctly and that they are tight! Dirty
couplings and sealing rubber leak and allow
water to escape under pressure, which inevitably
leads to blockages.
Carefully fasten risers so that they do not break
off under their own weight..
2. Lay mortar hoses with a radius large enough so that the hoses
do not kink.
3. Carefully fasten the riser so that it does not break off under its
own weight.
2
1
3
2
1
