Part 2 EC Declaration of Conformity Overview – Operation
End of shift / Cleaning
2020-03-25
53
54.3 Switching on the machine after removing a blockage
3
2
4
1
Fig. 91: Switching on
1. Selector switch (1) at “Zero” position (middle position).
2. Close the air tap on spray gun.
3. Turn the main switch (3) to the “I” position.
4. Turn potentiometer (4) for motor speed / material volume to
position 7 (readjust as required).
5. Turn the selector switch (2) to the right.
6. Run the machine briefly without mortar hoses
7. As soon as material emerges from the mortar pressure gauge,
switch off the machine at the pump motor (2) selector switch
(position "0”)
8. Pre-lubricate cleaned mortar hoses with wallpaper paste and
connect them to the machine and the spraying unit
9. Switch on air compresso
10. Turn the pump motor (2) and vibrator (1) selector switch to the
right, open the air valve on the spray gun and operate the handle
as described in section 42.1.
55 End of shift / Cleaning
55.1 Switching off the energy supplies
Securing against restarting
DANGER!
Danger of death due to unauthorised restarting!
When working on the machine, there is a danger of
unauthorised switching on of the electrical supply.
This puts those in the danger area at extreme risk.
Before starting work, switch off all electrical power
supplies and secure them against being switched
back on again.
55.2 Cleaning RITMO
CAUTION!
Water can enter sensitive machine parts!
Before cleaning the machine, seal all openings
where water could enter and impair the safety
and functions of the machine (e.g.: electric motors
and control boxes).
NOTE!
Do not aim the water jet at electrical components,
such as the gear motor or control box.
