Mixing pump RITMO L plus FC-230V Overview – Operation
Applying mortar
2020-11-09
41
Fig. 78: Switching on the vibrator
2. Turn the selector switch (3) to the right.
3. The vibrator operates according to the set interval times,
3 seconds pause – 3 seconds runtime.
45 Applying mortar
DANGER!
Danger of injury due to leaking mortar!
Escaping mortar can lead to injuries to the eyes
and face.
– Never look into the spray gun.
– Always wear protective goggles.
– Always position the machine so that you cannot
be hit should mortar escape.
NOTE!
The maximum pumping distance depends primarily
on the flow characteristics of the mortar.
Heavy, coarse-grained mortar does not flow well.
Fluid materials have good flow characteristics.
If an operating pressure of 20 bar is exceeded,
the hose length must be shortened.
45.1 Opening the air tap on the spray gun
Fig. 79: Switching on
Fig. 80: Opening the air valve
1. Turn the selector switch Pump motor directions of rotation (1) to
the right.
2. Point the spray gun toward the wall to be plastered.
3. Check that no-one is in the spray gun range.
4. Open the air valve (2) on the spray gun.
5. The machine starts automatically via the pressure switch-off
and mortar emerges at the spray gun.
NOTE!
The right mortar consistency is achieved if the
material on the sprayed surface merges (we
recommend applying material to wall surfaces from
top to bottom). Uniform mixing and spraying cannot
be ensured if the amount of water is insufficient.
This can clog the hoses and the pumping
components are then subjected to greater wear.
1
2
3
