Mixing pump RITMO L plus FC-230V Overview – Operation
Shutting down RITMO L plus in an emergency
2020-11-09
45
49 Shutting down RITMO L plus in an emergency
49.1 Emergency OFF switch
Switching off in an emergency
Machine movements and the energy supply must be disabled as
quickly as possible in dangerous situations.
Fig. 91: Switching off
Proceed as follows in the event of an emergency:
1. Turn the main switch to position “
0
”.
2. Secure the main switch against being activated again using
a padlock.
3. Inform supervisors at the site.
4. If necessary, call emergency services.
5. Remove persons from the danger zone and carry
out first-aid measures.
6. Ensure emergency vehicles have unobstructed access.
7. If the seriousness of the emergency warrants this, inform
the responsible authorities.
8. Assign specialist personnel to begin rectifying the fault.
WARNING!
Danger of death due to premature restarting!
All persons in the danger zone are at extreme
risk when the machine is switched back on.
Ensure that the danger zone is clear before
switching the machine back on.
9. Check the equipment before switching it back on and ensure
that all safety devices are in place and functioning properly.
50 Measures to be taken in the event of a power failure
50.1 Turning the main switch to position “0”
Fig. 92: Switch at position “0”
1. Close the air tap on spray gun.
2. Turn the main switch to position “
0
”.
3. Disconnect the connector plug from the air compressor.
4. Have the power supply connection checked by an expert.
