Mixing Pump RITMO XL FU 230/400 reversible Overview – Operation
Measures against danger of frost
2019-05-13
57
Fig. 92: Disconnect water supply
1. Remove hose (1) from water connecting piece on the rubber
mixing zone.
2. Remove water hose (2) from water inlet.
Fig. 93: Removing the mixing shaft
3. Take mixing shaft (3) out of the mixing zone.
4
Fig. 94: Opening the outlet tap
4. Open outlet taps (4) on the fitting block.
5. Allow water to drain off and close outlet taps again.
NOTE!
Make sure that the water fully flows out of
the water manifold.
47.1 Blowing the water manifold dry
Fig. 95: Dry water fitting
1. Connect air hose with Geka coupling and EWO coupling to
the compressed air flange (1) and to the water connection
(2).
1
2
3
1
2
