Make sure mixing bin is DRY. If wet then dry before using.
Connect power – If using a generator make sure it is at least 20kva for 230V. Make sure switch on inside of control
box is set to correct voltage (400 or 230). Turn on
RED
main switch. Push
GREEN
power switch. If using 400V make
sure yellow light is
not
on, if on then power is going in wrong direction. Turn main
RED
power switch in other
direction. If using 230V then yellow light
should
be on indicating you have the correct current. Turn off. The
ONLY
Rotor/Stator you can use on 230V is the
Slimline
.
Connect water to the RITMO XL. ¾” hose is the best but you can also use ½”. Turn on water.
RITMO XL water connector, connect water from water supply here
Close all the water release valves on the RITMO XL (picture on next page), they are the ones leaking water when
the water was turned on. If nothing was leaking water then valves were already closed. Check water pressure.
Needs to be at least 2.5 lbs, if lower than 2.5 then need a water booster pump if one is not built into this particular
machine. If pressure falls below 2.5lbs then machine will shut off.
