Open top of mixing bin again. Remove mixing blade and replace with cleaning tool. Close top, turn
RED
start
button, Push
GREEN
power button, turn pump motor on and run machine a few seconds to clean inside of tube.
Make sure water is on. Open top of bin and check to see if clean. If not repeat process again. If you open the
mixing bin you must Turn
RED
start button again and push
GREEN
power button to activate controls.
Mixing shaft cleaning tool
Replace mixing blade when shaft is clean. Rinse and clean dry mortar bin.
Open lower water cap on mixing tube and clean with water.
Clean outside of machine with soapy water and brush. Rinse.
Turn off water on RITMO XL. Turn on main
RED
power switch, push
GREEN
power button. Turn on pump motor and
run machine for a few seconds draining all water out of machine. When water stops coming out the Rotor/Stator
then shut off.
DO NOT RUN TOO LONG WITH NO WATER IT WILL BURN UP THE ROTOR/STATOR!
Water should stop coming out here
Clean out the end of the ROTOR/STATOR by spraying the inside out with water.
Turn off main
RED
power switch. Unplug the machine.
