3)76:,1*
*%
0HDVXUHVDIWHU)LQLVKLQJ:RUN&OHDQLQJ0DLQWHQDQFH7UDQVSRUW
9HUVLRQ
BBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBB
________________________________________________________________________________________
-
Empty the material container
-
Briefly run the pump motor in reverse (pressure reduction)
-
Mortar pressure gauge has to read “0 bar”
-
Switch off machine and disconnect power cable from the mains
- Disconnect and clean the hoses
- Disassemble and clean the spray gun
- Clean the air nozzles
- Clean the hoses incl. mortar pressure gauge at the water mains with the aid of
sponge balls soaked in water
- Empty all hoses completely
127(
In the case of different hose diameters, the hoses should be separately cleaned, using
sponge balls of corresponding sizes.
- Repeat this procedure if the hoses are heavily soiled
127(
Clean the machine with sponge, brush and water.
Do not use high-pressure or steam-jet cleaners, because otherwise water may
penetrate the bearings, switches, sockets, plugs etc. and cause damage!
-
Clean the material container
-
Discharge dirty water through the cleaning opening
-
Flush the pump with clean water
-
Rinse the pressure flange
:$51,1*
0DLQWHQDQFH
2LO/HYHO&KHFN2LO6HDOLQJ8QLW
Check the oil level at the sight glass of the oil sealing unit every day (mid-level).
Fill in lubricating oil 10 W 40 if necessary.
The conveying pump PFT SWING II does not require any other maintenance
measures.
7UDQVSRUW
The small, handy design of the conveying pump PFT SWING II permits comfortable
transport on construction sites, by holding it at the handle of the control box holder and
pushing it like a sack barrow.
For transport in a vehicle, for example, the control box and its holder can be separated
from the machine by opening the two lateral spagnolets and detaching the complete
assembly.
To reassemble the machine, connect the two forks of the control box holder to the
axles on the material container and turn them in the direction of the container until the
spagnolets catch.
For transport with a hook, the control box has to be properly locked, and all loose parts
have to be removed.
