PFT Conveying Pump SWING L Overview – Operation – Spare Parts Lists
Material
20
14/09/2021
20 Material
For all pumpable ready-mix dry mortar such as:
Adhesive mortar
Reinforcement plaster
Finishing plaster
Plastic plaster
Silicate plaster
SPCC restoration mortar
Multiple component materials
For liquid materials such as:
Emulsion paints
Primers
Betokontakt
Fig. 12: SWING L* - HM
*Accessories 00253076
PFT Protection grille SWING L deeper
For wet products and materials with a paste-like
consistency such as:
Finishing plaster of up to 3 mm granulation
Ornamental plaster
Bentonite
Adhesive mortar
Restoration mortar
20.1 Flow characteristics
NOTE!
The TWISTER D 6-3 pump can be used with an operating pressure of up to 30 bar.
The D 8-1,5 pump can be used with an operating pressure of up to 15 bar
The maximum conveying distance depends primarily on the flow charactistics of the mortar.
Heavy, coarse-grained mortar does not flow well. Fluid mortars, filling compounds and
paints flow easily.
It is recommended to reduce the length of the mortar hose if you exceed an operating
pressure of 30 /15 bar.
To avoid machine breakdowns and excessive wear on pump motor, pump shaft and pump,
always use original PFT spare parts such as:
PFT
rotors
PFT
stators
PFT pump shafts
PFT
material
hoses
These components are compatible with one another and form a single constructive unit
together with the machine.
Failure to follow these recommendations will result not only in the voiding of the warranty,
but the quality of the mortar you are producing will also suffer.
