PFT
Conveying Pump SWING L
Overview – Operation
– Spare Parts Lists
Setting up th
14/09/2021
25
27 Setting up the machine
Fig. 17:
Risk of injury
Before operating the machine, carry out the following preparations:
DANGER!
Rotating screw pump shaft!
Reaching into the material hopper poses a risk of
inury.
Therefore:
The protective grille should not be removed while
preparing or operating the machine.
Never reach into the machine while it is running.
If the protective grille is removed, the machine
switches off.
Fig. 18:
Setting up the machine
Install the machine on stable and even ground and secure it against
accidental movements:
Lock the locking roller before starting the machine.
Do not tilt or roll the machine.
Place the machine where it cannot be hit by any falling objects.
The controls must be freely accessible.
Maintain a free space of approx. 1.5 meters around the machine.
27.1 Monitor the machine
WARNING!
Access by unauthorized persons!
The machine may only be operated in a monitored
state!
ill the SWING L material container with approx. Two liters of wallpaper
paste so that the worm pump does not run dry when starting up and
testing.
