PFT Conveying Pump ZP 3 XL MIX Part 2 Overview – Operation - Spare Parts Lists
Putting the Drum Mixer into Operation
24
Fehler! Formatvorlage nicht definiert.
After the last shovel mix, let at least 30 seconds to pass until the
filling is uniformly mixed through.
Pay attention to correct mortar consistency. Consult with a
specialist on this.
Clean the interior and exterior of the drum mixer thoroughly
before every long work recess.
Wall- and plaster mortar usually consist of one part lime
and/or cement and three to four parts sand. The water
addition should occur based on the required consistency.
Consult with a specialist on this.
8.4 Turning on the Drum mixer
Fig. 27: Turning on the drum mixer
Switch On the mixer.
As for the mixer with a three-phase current motor, the rotating
direction of a drum mixer must be checked after turning On. It must
rotate in anticlockwise direction, viewed towards the opening (to
the left). If this is not the case, the phases of the supply line must
be reversed.
CAUTION!
The reversal of the terminal phases may be
carried only by an electrical specialist.
HINT!
If the drum mixer is blocked longer than a minute,
the thermal protection of the motor responds and
interrupts the circuit.
To put the mixer again into operation, deactivate the
mixer, let it cool down and turn it on again.
Fig. 28: Emptying the drum-type mixer
To empty the mixer, tilt the running drum downwards and lock it in
the respective emptying position.
We recommend that you empty the drum mixer slowly.
After emptying, swing the drum mixer again towards the top.
1
