NewFEIMAS
Refer to Revision Record on page 2.
T.Anzai
Nov. 20, 2008
K.Okada
Rev
04
03
PAGE
77
/
138
PFU LIMITED
P1PA03334-B30X/6
Refer to Revision Record on page 2.
T.Anzai
July 7, 2008
K.Okada
Refer to Revision Record on page 2.
K.Okada
K.Okada
DESCRIPTION
CHECK
DATE
T.Anzai
APPR.
K.Okada
K.Okada
Aug.19, 2005
DESIG
N
DESIG
.
CUST.
I.Fujioka
I.Fujioka
T.Anzai
CHECK
fi-5530C/fi-5530C2
IMAGE SCANNER
MAINTENANCE MANUAL
APPR.
TITLE
DRAW.
No.
Feb.23, 2007
05
Section 4-9-4
4-9-4. Replacing the Lamp SR (for ADF backside)
As the dust-proof area in the scanner is opened by the following procedure, do not replace the following parts in a dusty
room.
Refer to
Section 6-5
for the part number of the replacement part.
<Removing>
(1) Remove Chute unit (ADF paper chute), Stacker unit and Upper cover by referring to Sections from
4-7-1
,
4-7-2
and
4-7-5
.
(2) Remove the Optical unit by referring to
Section 4-9-3
.
(3) Disconnect the Lamp cable connector from the Inverter SR.
(4) Release three craws from the Reflector, and then remove the assembly of Reflector and Lamp.
<Mounting>
(1) Follow the removing procedure in reverse. Take care that slim cable is routed as follows.
(2) After mounting the Lamp SR, perform the following adjustment:
■
Offset adjustment (Refer to
Section 5-1-4
)
■
White balance adjustment (Refer to
Section 5-1-5
)
■
Magnification adjustment (Refer to
Section 5-1-3
)
Slim cable (shall be
routed under thick
cable)
Connector
Three claws
Assembly of Reflector and Lamp SR
Inverter SR
Three claws
