PG Drives Technology
R-net Bluetooth Modules Technical Manual | Chapter 1 - Operation
7
CHAPTER 1 - OPERATION
1
INTRODUCTION
The R-net Bluetooth Modules allow a wheelchair user to control a Bluetooth
enabled device through the R-net Control System, either through a Joystick or
via a Specialty Input Device (SID) connected to the R-net Omni. Typical
applications include PC mouse control or operation of a Smart device.
Up to two Mouse Modules and one iDevice Module may be connected into an
R-net Control System, so enabling simultaneous control of three Bluetooth
devices, one being an iOS device. However, the Mouse Modules must be of
different PGDT part numbers – D51111 and D51523; and the iDevice Module
must be D51580. If two Mouse Modules or two iDevice Modules of the same
part number are connected, then the system will not function correctly. If only
one Mouse Module is required, then any of the Mouse Module part numbers
may be used. Here is a summary of the current part numbers:
D51111 – Mouse Module – Can be used with PC or Android Smart devices
D51523 – Mouse Module – Can be used with PC or Android Smart devices
D51580 – iDevice Module – Can only be used with iDevices
Collectively, the above are referred to as Bluetooth Modules.
Operation of the R-net Control System will vary depending on what
Input Devices are connected. Refer to wheelchair manufacturer’s
documentation to establish the correct setup requirements for the
wheelchair.
